It will take a big signal reduction before the iphone (for example) will swap to higher signal. The iOS which are the more important in terms of roaming can be poor. Where my phone or whatever automatically switches to the strongest signal. each extreme (older flat ones I guess as distinct from the tower) will be in extend by wire which means it is bridged (not routing) and it will create a wireless network with same name and same password as the tower. That is standard setup and called roaming network. Then, the device will usually pick up the signal from the closest AirPort. To get these devices to switch AirPorts, you may likely need to toggle the WiFi off and then back on again when the device reaches a new location. But.most mobile devices like iPhones, iPads, PCs, etc will not do this very well.if they do it all. In practice, Mac laptops will usually do a nice job of automatically switching from one AirPort to another as they move about the house to pick up the best signal. In theory, wireless devices will pick up the WiFi signal from the closest AirPort as they move about the house. This will result in a network where all of the AirPorts provide a wireless signal that uses the same wireless network name, same wireless security, and same password. In the example below, you can see that an AirPort Express is being set up to connect to an AirPort Extreme, which is the "main" AirPort connected to the modem. The best that you will do is a "roaming" network, which in effect could be called a simple mesh.ġ) Set up an AirPort to connect to your modem as the "main" AirPort.Ģ) Connect all other AirPorts back to the "main" AirPort using a wired Ethernet cable connection.ģ) Using the AirPort Utility set up "wizard", configure all other AirPorts one at a time to "extend using Ethernet". Apple does not offer a true "mesh" type of network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |